Without this flame there would be no heat and thus no warm water.
Rheem gas water heater pilot light keeps going out.
If so turn off the gas.
The water heater pilot light is a small flame that ignites the gas burner on your water heater.
A pilot light is a small device that is designed to provide the flame and light the gas coming out of the gas valve and main burner.
If the pilot keeps going out the burner won t turn on and thus the water won t be heated which makes troubleshooting an important aspect of water heater maintenance.
A leak in the output duct of the furnace could cause air to blow into the area.
When the water heater pilot light goes out first try relighting it following the directions on the water heater label.
It is common on fireplaces and older cheaper furnaces and water heaters.
So what are the reasons your water pilot light keeps going out.
If the pilot doesn t relight if it goes out right after lighting or if the pilot light keeps going out by far the most common.
It s a small blue flame that burns petroleum gas to produce heat.
The pilot light is the heart of your water heater.
If you can light your pilot light but the water heater pilot keeps going out there are many possible causes.
After about 30 seconds heat from the ignited pilot light flame activates a simple electrical switch called a thermocouple which ensures that the gas supply to the pilot stays open and your water heater keeps functioning.
If your pilot light re lights easily after going out overnight it s possible it was blown out by a draft.
One of them is a dirty thermocouple.
A pilot light is always burning while using a small amount of gas either a water heater is running or not.
The pilot light needs to b.
The heater goes out at least once a day often many times over the course of the day.
When you have a problem with your water heater not lighting look at your water heater pilot light.
When the water heater is first lit a valve releases gas into the burner and the pilot light ignites that gas.
This can happen on excessively windy days or nights.
Inspect the thermocouple to determine if it is dirty.